Daily maintenance
1、Cleaning the table, adjust screw rod handle and the column strip.
2、Check, adjust the clutch.
3、Three to guide and felt cleaning, motors, machine tools and accessories clean inside and outside.
4、Check the oil line, filling the lubricating oil.
5、Fastening the screw.
When the milling machine is not in use for a long time maintenance
一、Clean
1、Disassembly and cleaning the oil wool felt.
2、Wipe the sliding surface and the guide surface, wipe the table and the horizontal, the lifting screw rod, wipe away the knife driving mechanism and a cutter frame.
3、Wipe the Department of dead ends.
二、Lubrication
1、The oil hole cleaning and Lubricating oil.
2、The guide surfaces and the sliding surface and the screw filling of lubricating oil.
3、Check the transmission mechanism of oil tank body, oil, and gas to the elevation.
三、Tightening
1、Check and tighten plate and gib screws.
2、Check and tighten the screw, feed driving mechanism ,handwheel ,table bracket screw,fork top wire.
3、Check and tighten other parts of loose screws .
四、 adjust
1、Check and adjust the belt, plate and strip tight.
2、Check and adjust the slider and screw in order.
五、Anticorrosive
1、Remove the rust, protect the paint surface, not collision.
2、Rail surface of disable the standby equipment, , sliding screw hand wheel and other exposed rusted in the outer parts of the coating anticorrosion.