Milling machine case scope of operation

1, the lathe bed and parts cleaning, cleaning iron filings and the surrounding environment health;
2, check the oil surface, shall not be lower than the oil under the standard, each part of the filling of lubricating oil;
3, cleaners, clamp, measuring tool.
A milling machine operating range
1, wash adjust workbench, screw the handle and strip on the pillars;
2, check and adjust the clutch;
3, clean to the guide rail and felt, motor, machine clean inside and outside and accessories;
4, check the oil, filling each lubricating oil;
Five ministries, fastening screws.
Milling machine case scope of operation
1, lathe bed and parts cleaning, cleaning the iron filings and the surrounding environment health, cleaners, clips, measuring tool;
2, check the oil surface, shall not be lower than the oil under the standard, each part of the filling of lubricating oil.
Milling machine maintenance work scope over the weekend
A, clean
1, remove the cleaning each felt pads;
2, wipe the slip surface and the guide surface, wipe the table and transverse, lift screw transmission mechanism and the tool rest, wipe away the edge of the sword;
3, wipe each corner.
Second, the lubrication
1, the oil hole cleaning unblocked and infuse lubricating oil;
2, the guide surface and slip surface and the screw filling lubricating oil;
3, check the driving mechanism of oil casing, oil level, and go to level position.
Third, twist
1, check and tighten clamp and gib screw;
2, check and torsional sliding block is fixed screw, feed screw transmission mechanism, the handwheel, workbench support, fork top wire;
3, check the twist other parts loose screws.
Fourth, adjust the
1, check and adjust the belt, pressure plate and strip the consistence;
2, check and adjust the slider and the screw in order.
Five, anticorrosive
1, ministries to remove rust, protect the paint surface, not collision;
2, stopping and backup device guideway, sliding screw handwheel and other exposed corrosion rusty parts with oil easily.